Installation Guide

84
DESIGNER RAILING
HOW TO INSTALL STANDARD RAILING/CONTINUED
DESIGNER SERIES
2
10
3
1
1
1
9
x2
3
2
Top
Rail
Top
Rail
Bottom
Rail
Bottom
Rail
Securing Railings to Posts
9. Place assembled railing section on RSBs on posts
and secure top rail with two 1-1/2" (3.8 cm) screws.
Secure bottom rail with screws through top of rail
and into the outermost hole in RSBs.
Bottom rail can also be secured to posts with
16 gauge finishing nails, toenailed from bottom of
rail and 1" (2.5 cm) in from the posts.
Finishing Post
10. Posts and post sleeves can be trimmed but this is
not a requirement. Make sure tops of posts are level.
Secure post caps with construction-grade adhesive.
Clean-up any excess adhesive before drying.