Installation Guide

105

ADA HANDRAIL

Post Return - Angled

1. Apply adhesive to all metal contact surfaces. Slide

adjustable joiner into post return and aluminum

rail support. Make sure adjustable joiner is plumb.

2. Pre-drill holes using 1/4" (0.6 cm) drill bit and

attach bracket to mounting surface using an

appropriate connector (a 3/8" (1 cm) lag bolt at

least 2" (5.1 cm) long should be used when

mounting to a wood surface).

3. Place post return at appropriate location on

bracket. Pre-drill two holes in post return with an

11/64" (0.4 cm) drill bit at appropriate location and

attach with screws (provided).

4. Snap bolt cover into place.

Straight Joiner

1. Apply adhesive to all metal contact surfaces.

2. Optional: Position joint ring between rail sections.

3. Slide joiner into both aluminum rail supports until

the joint is tight.

Angled Corner

1. Cut the aluminum and PVC tube to proper length at

desired angle.

2. Apply adhesive to all metal contact surfaces.

3. Slide rails together until the adjustable joint is tight.

NOTE: A PVC adhesive may be used to ensure a tight seam on the exterior tube. Make sure adhesive cures per manufacturer’s

instructions.

HOW TO INSTALL TREX

ADA RAILING

METAL ADHESIVE