Installation Guide

TRANSCEND RAILING

HOW TO ATTACH CLASSIC STYLE GLASS PANEL RAILING/CONTINUED

TREX TRANSCEND

9. Place inverted deck board (place top side of deck

board down) on clean, ﬂat surface. (DO NOT use

Escapes, Select, or Contour deck boards for

top rail.

10. Place Universal rail (remembering to orient this

properly so that when ﬂipped over the Universal rail

will accept the baluster spacer and balusters), on

the deck board, centered in both directions to allow

for ﬁnal attachment to post.

11. Secure deck board to Universal rail with 2" (5.1 cm)

pan head screws (provided) approximately every 16"

(40.6 cm) on center. (DO NOT overtighten.)

12. Place inverted Universal rail with deck board

attached onto RSB’s with glass panel in the channel.

Attach Universal rail to RSB’s with two self-tapping

screws (provided).

13. Attach deck board

to post (ensure that

screws are attached

to wood post) with

Trex recommended

composite screws at a

diagonal.

14. Install four panel

support moldings

(PSM) into rails

to complete snap

connection. Both

the top and bottom

PSM edges rest on

the lip of the rails for

both Universal and

Beveled rails.

Hiding Brackets

15. Cut Transcend baluster spacer into four lengths

equal to distance between the glass panel and posts.

Cut slowly and one at a time, to avoid chipping.

16. Snap spacer into bottom and top rail to hide

brackets and create a seamless look.