Installation Guide

103
ADA HANDRAIL
90° Wall Return
Cut the aluminum and PVC tube to proper length.
1. Apply adhesive to all metal contact surfaces.
2. Make sure flange cover is placed over PVC rail prior
to assembly.
3. Slide straight joiner into wall return and
aluminum rail support.
4. Attach mounting flange to desired surface. Snap
flange cover into place.
NOTE: Hardware not included.
Straight Wall Return
Cut the aluminum and PVC tube to proper length.
1. Apply adhesive to all metal contact surfaces.
2. Make sure flange cover is placed over PVC rail prior
to assembly.
3. Insert straight wall return into aluminum rail support.
4. Attach mounting flange to desired surface. Snap
flange cover into place.
NOTE: Hardware not included.
Handrail Bracket
1. Predrill hole using 1/4" (0.6 cm) bit and attach
bracket to mounting surface using an appropriate
connector (a 3/8" (1 cm) lag bolt at least 2" (5.1 cm)
long should be used when mounting to a wood
surface).
NOTE: Lag bolt is not included.
2. Place the rail at appropriate location on bracket.
3. Pre-drill two holes in the rail with an 11/64" (0.4 cm)
drill bit at appropriate location and attach with
screws (provided).
4. Snap bolt cover into place.
5. Using PVC adhesive, attach handrail end cap (sold
separately) to unfinished end of rail.
90° Corner
Cut the aluminum and PVC tube to proper length.
1. Apply adhesive to all metal contact surfaces.
2. Slide straight joiner into each side of corner and
aluminum rail supports.
HOW TO INSTALL TREX
®
ADA RAILING
4
1
2
3
4
5
METAL ADHESIVE
2
1
3
2
4
METAL ADHESIVE
3
1
3
2
4
METAL ADHESIVE
5
1
2
2
NOTE: A PVC adhesive may be used to ensure a tight seam on the exterior tube. Make sure adhesive cures per manufacturer’s
instructions.