Installation Guide

SELECT RAILING

Read all instructions BEFORE installation.

NOTE: Foot blocks must be placed before

installing bottom rails.

NOTE: One centered foot block is required for

every section of railing or stairway section.

Attaching Foot Block to Bottom Rail

1a. Center and cut bottom rail to ﬁt between post span,

making sure to cut from both sides of bottom railing

to allow for balusters to be equally spaced.

1b. Invert the Select bottom rail.

1c. Center foot block on Select bottom rail. Drill 1/16"

(0.15 cm) pilot hole through center of rail, then

attach foot block to rail using 2" (5.1cm) screw

(provided). DO NOT extend foot block.

Drill Pilot Hole for Foot Block Base Plate

2. Center bottom railing with foot block attached (DO

NOT EXTEND FOOT BLOCK) in between post

span. Place base place directly under location of

foot block placement and mark accordingly.

Installing Foot Block Base Plate

3. Remove rail. Position foot block base

plate at marked locations and drill a

1/16" (0.15cm) pilot hole into deck

board. SECURE foot block base plate

with #10 x 3/4" (1.9 cm) stainless steel

screws (provided).

Installing Select Railing Section

4. Install Select horizontal railing section as per

instructions provided with Select Railing.

HOW TO INSTALL TREX

SELECT™ RAILING FOOT BLOCKS

TREX SELECT™

Center

Line

(7.6 cm)