Installation Guide

81
RAILING
81
DESIGNER RAILING
TREX DESIGNER SERIES RAILING
®
NOTE: Position of bottom rail lip is not a structural component. It is
recommended that it be consistently installed either inside or outside.
Trex Designer Series Railing
®
Parts
A. Top rail
B. Bottom rail
C. Railing support brackets (RSBs)
D. Balusters*
E. Post sleeve*
F. Post sleeve cap*
G. Post sleeve skirt*
H. TrexExpress
™
Designer Series Railing
Assembly Tool*
* Item not included in Designer Railing Kit
NOTE: Architectural baluster cannot be used with
Designer Series Railing.
A
B
C
D
Standard
Cutting post sleeves is NOT required.
A. Pressure-treated post or Trex Post Mounts with Trex post sleeve
B. Top rail
C. Bottom rail
D. Trex Designer standard balusters
See page 82 for “How to Install Standard Railing”.
Contemporary
Cutting post sleeves is NOT required. Follow instructions for standard Designer
installation, using metal balusters for square balusters.
A. Pressure-treated post or Trex Post Mounts with Trex post sleeve
B. Top rail
C. Bottom rail
D. Trex Designer contemporary balusters
See page 85 for “How to Install Contemporary Railing”.
DESIGNER COLORS: See inside back cover for color palette.