Installation Guide

HOW TO INSTALL DECKING

4b. Use center holes for inline applications and offset

holes for corner applications.

Install Guide Blocks

5. Place the two guide blocks onto post mount. Insert

self-tapping screws (provided) to secure.

Install Railing System of Choice

NOTES: If installing a Trex® railing system:

» Mark screw placement on post sleeve for the

rail support brackets (RSBs).

» Pre-drill screw holes through post sleeve and

aluminum guide blocks with a 1/8" (0.3 cm) drill bit.

» Attach RSBs using 1-1/2" (3.8 cm) . screws

(provided) for 4" x 4" (10.2 cm x 10.2 cm) Trex post

sleeves.

» Attach RSBs using 2" (5.1 cm) screws (provided)

for 6" x 6" (15.2 cm x 15.2 cm) Trex post sleeves.

NOTE: If installing Trex Decklighting

™

on the posts,

drill hole through bottom plate as well as any

support blocks to allow wiring for lights to be below

the surface of the decking.

DECKING:

HOW TO INSTALL POST MOUNTS ON CONCRETE

NOTE: Cannot be used with Trex Transcend® Classic railing

or Trex Traditional railing styles.

PARTS

Inline

Offset

HOW TO INSTALL POST MOUNTS ON DECK BOARDS/CONTINUED

» (1) Post mount

» (2) Guide blocks

» (4) 3/8" x 3" (0.8 cm x 15.2 cm) Concrete bolts

» (4) 5/16" x 1" (0.8 cm x 2.5 cm) Hex (leveling) bolts

» (1) Leveling plate

» (4) Flat washers

» (4) 3/4" (1.9 cm) Self-tapping screw

» (8) 1-1/2" (3.8 cm) Stainless steel screws

» (8) 2" (5.1 cm) Stainless steel screws