Installation Guide

Trex® Seclusions® Fencing Product Information and Care & Cleaning Guide
Trex
®
Seclusions
®
Fencing
www.TrexFencing.com
Installation Assistance
Professional installation support is just a phone call or email away: 1-877-700-8739 or [e-mail].
Trex® Seclusions® Fence Colors
Saddle Woodland Brown Winchester Grey*
*When it is new, Winchester Grey looks similar to Woodland Brown. As it weathers shortly after installation, it will lighten to a
grey color.
Care & Cleaning Guide
Dirt and Debris
Clean fence to remove dirt and debris. Soap, hot water and a soft brush are all that is needed.
Chalk Markings
Most colored chalk lines are permanent. For Trex® use either baby powder or Irwin Strait-Line dust-
off marking chalk available at:www.irwin.com
Water Spots, Leaf
Staining and Wood
Tannins
Tannin leaching occurs in Trex® and all wood based products naturally. Allow for at least 12 weeks
of normal weathering. This process may be hastened through the use of a product containing
oxalic or phosphoric acid commonly known as Deck Brightener. *
Scuffs & Abrasions
Scuffs and abrasions can fade or disappear naturally after 12-16 weeks of weathering. If a
reduction in the visibility of a scuff or abrasion as the fence weathers, WD-40 can be applied to
the affected area for a temporary solution. To accelerate fading, a product containing oxalic or
phosphoric acid, also known as Deck Brightener. *
Rust Stains, Ground-In
Dirt and Grime and
Pigment Staining
Use a cleaning product containing oxalic or phosphoric acid base, also known as Deck Brightener
to lighten or remove the rust or dirt. Product may need to sit on stain 10-15 minutes before rinsing. *
Oil and Grease Stains
Rinse the stain with hot water as soon as possible. Use Pour-N-Restore (www.pour-n-restore.com) as
directed for any remaining stain (test in a small area first as this may remove some of the colorant
from the fencing surface).
Mold & Mildew
Semi-annual (Spring and Fall) cleaning of your fence is important to prevent the build-up of pollen
and other debris that can support the growth of mold. Use conventional fence washes or cleaners
that contain sodium hypochlorite (bleach) and detergent (refer to the Mold Technical Bulletin for
specific recommendations). *
Pressure Washer
Trex Company does not recommend the use of a pressure washer. The use of a pressure washer
with a greater than 1,500 PSI and/or applied closer than 12″ from the fence surface could
damage the fencing surface and result in a loss of warranty coverage.
Sanding
Trex Company does not recommend sanding. Sanding will change the appearance of the
surface of Trex® material and will void the warranty.
Disposal
Trex® products should be disposed with normal construction debris or household waste. Do not
burn Trex® products.
* Use of products containing bleach or acid will lighten the surface of Trex®. Use in an inconspicuous area to determine if
lightening is esthetically unpleasing to you. Neither product will affect the structural integrity of Trex® composite fencing.
PLEASE READ CAREFULLY
Do not return product before contacting Trex Fencing for instructions: 877-700-8739