Installation Guide

Advanced Tips and Tricks:
TREX SECLUSIONS
®
INSTALLATION GUIDE
STEP 7: CUT & INSTALL BOTTOM RAILS
STEP 8: CUT TOP RAIL
A
Measure between the post or for a more accurate cut, hold the
aluminum bottom rail next to the posts in line with the rail brack-
ets, with the deeper pocket facing down. Mark the bottom rail to
transfer angles to ensure accurate cuts. Cut the rail using a non-
ferrous metal cutting blade (Wear Eye Protection). Cut the rail
1/2” smaller to avoid scratching the posts during installation.
B
Repeat the procedure with two bottom rail covers (face
them in opposite directions), but do not cut them
shorter so you can maintain a tight fit. Cut the rail
covers using a circular saw or miter saw.
C
Slide the bottom rail covers over the bottom rail.
D
Slide the assembled rail over the bottom rail brackets.
A & B
C
D
A1
When dealing with a slope or complex angle, set your top rail
on top of your posts. Hold your speed square against the post
and mark the rail. Repeat on the other post.
A2
For a complex angle, mark the rail underneath where it crosses
the post. Repeat on the other post.
C
Test fit the top rail on the brackets. Leave in place while
cutting and fitting top rails for the remaining sections to
ensure everything fits properly.
A1
Bottom
A2
A3
Determine the miter angle by laying your speed square on the
side of the top rail in line with your mark. Make sure the pivot
point touches the bottom edge of the rail. Read the angle by
noting where the bottom edge of the rail crosses the gauge.
Set the miter angle of your compound saw to this angle.
A3
A4
A4
Determine the bevel angle by laying your speed square on the
bottom of the rail in line with your mark. Make sure the pivot
point touches the edge of the rail. Read the angle by noting
where the edge of the rail crosses the gauge. Set the bevel
angle of your compound saw to this angle.
B
Place the rail on your miter saw with the top side
against the fence. Line the blade up with your marks
and cut the rail. Repeat the process with the other end
(If using a circular saw, transfer mark around top cap
before cutting).
D
Remove the top rails and set aside until after the
pickets are in place.
A
It is easier to measure and mark your top rail before the pickets
are in place. Measure between posts or hold your rail next to
the post in line with the top rail brackets and mark the rail to fit.
A
PIVOT
POINT
PIVOT
POINT
ANGLE
ANGLE
©201
6 TFSC
B