Instinct Installation Manual

CHAPTER 9 - CTRLMAX OPERATION
51
EZ Setup
DHW EZ Setup
DHW Setpoint
140°F
68°F
168°F
DHW
Warmstart Temperature
125°F
86°F
Off
140°F
DHW
Warmstart Hysteresis
30°F
9
36°F
EZ Setup Complete
DHW EZ setup is complete.
Additional changes can be made in
the Installer Menu if required.
Press OK to return to EZ Setup Menu
DH W E Z S et up p r omp t s th e i n s t a ll e r t o s e l e c t th e D HW s et po i n t .
DHW
Setpoint prompts to enter the fixed setpoint temperature
during a domestic hot water call.
Touch the
then touch
or
soft keys to adjust the temperature setpoint
to store the setting. The DHW Warmstart Tempera-
ture
screen then appears .
Default: 140°F [60°C].
DHW Warmstart Temperature prompts to enter the DHW tem-
perature in case you want to speed up the delivery of DHW in sum
-
mer
conditions.
Touch
the or soft keys to adjust the temperature then touch
to store the setting. At the minimum temperature (86°F), this
function is OFF. The
DHW Warmstart Hysteresis screen then ap
-
pears
.
Default:
125°F [52°C].
DHW Warmstart Hysteresis prompts to enter the DHW hysteresis
value, comprised between 9°F (5K) and 36°F (20K).
Touch the
touch
or
soft keys to adjust the hysteresis value, then
to store the setting.
Default: 30°F (17k).
9.9. Domestic Hot Water EZ Setup - INSTINCT Combi Units
Domestic Hot Water EZ Setup allows the installer to quickly customize the Domestic Hot Water settings for the application
9.10. Altitude Setup
Combi
Altitude must be correctly set to allow reliable operation of the
bo il e r .
88°F
Fromthe homescreen touchthe or soft keys simultaneously for 5
ENTER ACCESS CODE
84°F
seconds and “Enter Access Code”screen will be shown.
Target = - -
Standby
CH & DHW Settings
0 5 [4]
Touch the or soft keys to set the access code to 054. Touch
and the CH & DHW Settings creen will be shown.
CH Settings
Touch and the CH Setting screen will be shown. Touch the
soft key and the “Boiler Settings” (list) screen will be shown.
Boiler Settings
Touch the soft key until the“Altitude” option is highlighted. Touch
and the Altitude screen will be shown.
Boiler Settings
Model
Instinct Combi
Lockout Temp.
Touch the soft key until the correct altitude is shown, then touch
Modbus Address
Pump Settings
B
2
o
10
i l
º
e
F
r
[ 9
S
9º
e
C
t
]
tings
1
Ig nition lev el
P ump S ett i
3
n
0
g
0
s
r pm
the soft key to highlight the home icon. Touch to confirm.
M ix z one highIg l n i m itii o t n lev el114ºF 3
A
0
l
0
t
0
it u
r p
d
m
e
Mix zone high limit 114ºF
WP
diff trigger 0cpsi
Appliance setting
Note. The altitude moves in steps of 984 ft (300m).
Altitude
4920
0 f
f
t
t
0ft
19680ft
CHAPTER 9