Instinct Installation Manual

64
FOR YOUR SAFETY, READ BEFORE OPERATING
WARNING
If you do not follow these instructions exactly, a fire or explosion may result,
causing substantial property damage, serious injury, or death.
A. This appliance does not have a pilot. It is equipped C. Use only your hand to turn the external manual gas
with an ignition device which automatically lights valve. Never use tools. If the valve will not turn by
the bur ner . DO NO T tr y t o light the bur ner b y hand . hand , don ’ t tr y t o r epair it; call a qualified service
B.
BEFORE OPERATING, smell all around the appliance
technician. Force or attempted repair may result in
ar ea f or gas . B e sur e t o smell nex t t o the fl oor because
a fir e or explosion.
some gas is heavier than air and will settle on the floor. D. Do not use this appliance if any part has been
WHAT TO DO IF YOU SMELL GAS
under water. Immediately call a qualified service
• Do not try to light any appliance.
technician to inspect the appliance and to replace
•
Do not touch any electric switch; do not use
any part of the control system and any gas control
any phone in your building
which has been under water.
•
Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
•
If you cannot reach your gas supplier, call
the fire department.
OPERATING INSTRUCTIONS
1. ST OP!
R ead the saf et y inf or mation abo v e . T his ap -
7. Turn the service switch on the appliance control
pliance is equipped with an ignition device which
panel “ON”.
automatically lights the burner. DO NOT try to light
8. Set room thermostat(s) to desired setting(s).
the bur ner b y hand .
9. The appliance control panel display will show the
2. Set room thermostat(s) to lowest setting. Turn the
current operating status on the Status Line at the
external manual gas valve handle clockwise
bottom of the screen. “Standby” means there is
to “CLOSE” (valve handle must be perpendicular to
no call for heat (all thermostats are satisfied).“CH
gas piping).
Demand” indicates a space heating call has been
3. Turn the service switch on the appliance control
received. “DHW Demand” indicates a domestic hot
panel OFF.
water call has been received. A flame icon will be
4. Remove the front jacket panel on the unit.
displayed when the unit is fired.
5. W ait fiv e (5) minut es t o clear out an y gas . I f y ou then
10. If the unit will not operate, follow the instructions
smell gas in the jacket enclosure or around the unit,
“To Turn Off Gas to Appliance” and call your service
STOP! F ollo w “B ” in the saf et y inf or mation abo v e . I f
technician or gas supplier.
y ou don ’ t smell gas , go t o the nex t st ep .
11. Replace the front jacket panel. Make sure the panel
6. Turn the external manual gas valve handle counter
is seated firmly in place and all mounting screws are
clockwise to “OPEN” gas supply (valve handle
tightened.
shall be parallel to gas piping).
TO TURN OFF GAS TO APPLIANCE
1. Set the room thermostat to lowest setting.
2. Turn the service switch on the appliance control
panel to “OFF”
3. Turn the external manual gas valve handle clock-
wise to “CLOSE”.