Prestige Solo Series Installation Manual

1
CHAPTER 1
CHAPTER 1 - PRE-INSTALLATION REQUIREMENTS
1.1. Code Compliance
The PRESTIGE Solo must be installed by a qualied in-
staller in accordance with the following:
• All applicable local, state, national and provin-
cial codes, ordinances, regulations and laws.
• For installations in Massachusetts, code requires
the PRESTIGE Solo to be installed by a licensed
plumber or gas tter, and if antifreeze is utilized,
the installation of a reduced pressure back-ow
preventer device is required in the boiler’s cold
water ll or make up water supply line.
• For installation in Massachusetts, all direct vented
appliances must comply with the guidelines as
outlined in Section 2.8 on page 8.
• The National Fuel Gas Code (NFPA54/ ANSI Z
223.1).
• National Electric Code (ANSI/NFPA 70).
• For installations in Canada - Installation Code for
Gas Burning Equipment (CAN/CSA B149.1), Ca-
nadian Electrical Code Part 1 (CSA C22.1).
• Standards for Controls and Safety Devices for
Automatically Fired Boilers (ANSI/ASME CSD-1),
when required.
The boiler gas manifold and gas controls meet
the safe lighting and other performance re-
quirements as specified in ANSI Z21.13.
NOTICE
1.2. Determining Product Location
The PRESTIGE Solo is certified for indoor,
conditioned space installations ONLY.
Before locating the PRESTIGE Solo check for convenient
locations to:
• Heating system piping
• Venting
• Gas supply piping
• Electrical service
Ensure the PRESTIGE Solo location allows the combus-
tion air/vent piping to be routed directly through the
building and terminate properly outside with a mini-
mum amount of length and bends.
Ensure the area chosen for the installation of the PRESTIGE
Solo is free of any combustible materials, gasoline, or oth-
er ammable liquids.
Failure to remove or maintain the area free
of combustible materials, gasoline, or oth-
er flammable liquids or vapors can result in
substantial property damage, serious injury,
or death.
Ensure the PRESTIGE Solo and its controls are protected
from dripping or spraying water during normal opera-
tion or service.
The PRESTIGE Solo should be installed in a location so
that any water leaking from the boiler, piping connec-
tions, or relief valve will not cause damage to the sur-
rounding area or any lower oors in the structure.
NOTICE
WARNING