Prestige Solo Series Installation Manual

56
A. This appliance does not have a pilot. It is equipped
with an ignition device which automatically lights
the burner. DO NOT try to light the burner by hand.
B. BEFORE OPERATING, smell all around the appliance
area for gas. Be sure to smell next to the oor because
some gas is heavier than air and will settle on the oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use
any phone in your building
• Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call
the re department.
C. Use only your hand to turn the external manual gas
valve. Never use tools. If the valve will not turn by
hand, don’t try to repair it; call a qualied service
technician. Force or attempted repair may result in
a re or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualied service
technician to inspect the appliance and to replace
any part of the control system and any gas control
which has been under water.
FOR YOUR SAFETY, READ BEFORE LIGHTING
OPERATING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
If you do not follow these instructions exactly, a fire or explosion may result,
causing substantial property damage, serious injury, or death.
WARNING
1. STOP! Read the safety information above. This ap-
pliance is equipped with an ignition device which
automatically lights the burner. DO NOT try to light
the burner by hand.
2. Set room thermostat(s) to lowest setting. Turn the
external manual gas valve handle clockwise
to “CLOSE” (valve handle must be perpendicular to
gas piping).
3. Turn the service switch on the PRESTIGE control
panel OFF.
4. Remove the front jacket panel on the unit.
5. Turn the external manual gas valve handle counter
clockwise
to “OPEN” gas supply (valve handle
shall be parallel to gas piping).
6. Wait ve (5) minutes to clear out any gas. If you then
smell gas in the jacket enclosure or around the unit,
STOP! Follow “B” in the safety information above. If
you don’t smell gas, go to the next step.
7. Turn the service switch on the PRESTIGE control
panel “ON”.
8. Set room thermostat(s) to desired setting(s).
9. The PRESTIGE control panel display will show the
current operating status on the Status Line at the
bottom of the screen. “Standby” means there is no
call for heat (all thermostats are satised). “CH De-
mand” indicates a space heating call has been re-
ceived. “DHW Demand” indicates a domestic hot
water call has been received. A ame icon will be
displayed when the unit is red.
10. If the unit will not operate with a call for heat and
the system piping is not hot, follow the instructions
“To Turn O Gas to Appliance”, below and call your
service technician or gas supplier.
11. Replace the front jacket panel. Make sure the panel
is seated rmly in place and all mounting screws are
tightened.
1. Set the room thermostat to lowest setting.
2. Turn the service switch on the PRESTIGE control
panel to “OFF”
3. Turn the external manual gas valve handle clock-
wise
to “CLOSE”.