Base-station user guide TriangleCNC Inc Revision: 1.
FCC Compliance Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Interference Statement This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
Table of contents 1. Hardware specification .................................................................................................................................................................. 3 1.1 General Specification ........................................................................................................................................................ 3 1.2 Hardware block diagram and dimension .............................................................................
1. Hardware specification 1.1 General Specification Item Description Product Input voltage 100 ~ 240VAC 50Hz/60Hz (external power source) Internal Input voltage DC12V (9 ~ 15V) (input voltage of board) Current 300mA @12V OS Linux Ethernet 10/100Mbps Internal connector - RF module connector External connector - RJ45 JACK (Ethernet 10/100Mbps) 1.
Board dimension 145.00 2) 110.
3) Description of connectors A B C D E Number A Name 12V Input connector Description - Molex 5569-04A1 connector - Pin number 1 : GND B Debug connector 2: GND 3: DC12 4: DC12V - D-SUB 9 straight - RS232 2 Port C RF Module connector - 2.
4) Description of switches F G H Number 5) Name Description F Power switch Toggle switch G Mode selection DIP switch 4Pin dip switch H Mode selection rotary switch 10digit rotary switch Description of LEDs I J Number Name Description I Power status LED 3pi LED J Program status LED Refer the next section Base-station board user guide Page 6 / 8
2.
3. Interface for user 3.1. Login into webpage 1) Login the webpage of base-staation by using ‘Internet Explorer’ 2) Login with default IP - Turn DIP switch #1 on, then supply power - Login with ‘192.168.1.100’ IP 3) Login account ID: ****** Password: ******** This device must be professionally installed and maintained by TRIANGLECNC corp. It is not allowed ordinary people personally installing the device.
