Operation Manual

DVB 168 S (GB)-18 050908
www.triax.com
18
Note on Network Search:
In this search mode, the receiver first collects the network information first from the TP you
selected. Then an Auto Search takes place to research all the channels in that network. The
number of searched channels may vary, depending on the TPs present in that network. Select
whether to use the network information of the TP stream specified in "Select Transponder".
I.e, download the TP information of the satellite you want to find from a particular TP and then
use this to Auto Search the channels in the TP group. The number of channels searched may
vary depending on the TP information transmitted. Select Network Search and then use the
buttons to set it.
9.7 Manual Search Function
Use this channel search by entering the TP information manually to the receiver. This channel
search is often used to search for a particular channel or those channels that "Auto Search"
has missed, but it requires comparatively more expertise.
Select "Manual Search" and then press the OK button.
Select the satellite you want to track.
Set the LNB information and DiSEqC information for the
satellite. You can use the existing setting. To change the
setting, use the buttons.
Set the LNB polarization of the TP to "Horizontal" or
"Vertical".
After the settings are completed, select "Next" and then
press the OK button.
Set the Down Frequency of the TP.
Set the Symbol Rate of the TP.
Select the type of channels to search: FTA, Scrambled, ALL or Network.
Press the OK button to start searching using the above settings.
Another search method is "Advanced Search". Use this channel search to search for a
particular channel or channels ones that you couldn't find using "Manual Search". Enter the
PID of the channel you want to search.
Set the channel's Video PID.
Set the channel's Audio PID.
Set the channel's PCR PID.
Press the OK button at "Start Search"
The names of the channels will be listed.
Press the EXIT button to return to viewing mode and check that the reception of the
selected channel is good.
9.8 Transponder Editor
The "Transponder Editor" allows you to change, add, and
delete satellite information.
Go to the "Main Menu", select "Installation", select
"Transponder Editor", and then press the OK button.
Add a Satellite
Use the buttons to move to the last field on the list.
Press the OK button. The screen will change to allow you
to enter the name of the satellite you are adding.
Use the buttons to enter letters. Use the buttons
to change the cursor position.
When you have finished entering the satellite name,
press OK.
Press the OK button to enter the added satellite's TP
information of the added satellite.
When the TP information input field appears in the right
panel, press the OK button.