Operation Manual

DVB 168 S (GB)-20 050908
Go to the Main Menu, select "Installation", select "Delete All Channels".
Enter password upon request
A warning message appears. Press "EXIT" to cancel or OK to confirm.
The "Welcome" screen appears.
Make your language selection and press OK.
Follow the instructions on the screen: either load the pre-programmed channel data or start
your individual channel search process.
www.triax.com
20
"Sending" appears on the sending receiver and "Receiving" appears on the receiving
receiver.
The transfer progress bar shows the progress of the channel data transmission. When the
transfer is completed, "Complete" appears.
You can check that the channel data on the Slave and Master receivers are the same.
PC to Receiver (PC - STB)
You will need a suitable software to be able to transfer the channel information from a
receiver to your PC and vice versa. This software will be provided upon request.
Please visit TRIAX website : www.triax.com
Use a RS-232C cable (cross type) to connect the Receiver to your PC.
In your PC programme set your PC as "3.Ch.Data Sender (STB->STB)". "Sender" signifies
the device that is transmitting the channel information.
On the receiver go the Main Menu, select "Installation" and then select menu option "Data
Transfer".
Set your receiver as "2.Ch.Data Receiver (STB<-PC)"
Follow the instructions on the PC program to complete the rest of this process.
9.10 Delete all Channels
This function will delete all channel data from the receiver.All other individual settings will be
kept.
9.11 Factory Preset
Go to the Main Menu and select "Factory Preset".
Enter password upon request.
A warning message appears. Press "EXIT" to cancel or OK to confirm.
The "Welcome" screen appears.
Make your language selection and press OK.
Follow the instructions on the screen: either load pre-programmed channel data or start
your individual channel search process.
This function will delete all channel data and all individual settings from the receiver. The pre-
programmed channel data will be loaded again, and all settings will be reset to their default
values.