Operation Manual

DVB S1
GB
9.6 Auto Search Function
Auto Search is the one used most frequently used methods of channel search. It is intended to
have the receiver automatically search all the channels from the satellite you selected.
Select "Auto Search" and then press the OK button.
Select the satellite using the OK button. If you want to
change the Satellite Information, press the GREEN button
on the remote control.
Set the LNB information and DiSEqC information for the
satellite. You can use the existing setting. To change the
setting, use the buttons.
You can select the transponder (TP) you want to use and
check the difference in signal strength and reception quality
from one transponder to another.
Set DiSEqC port to OFF (or to a port you want to use, if any)
Select the type of channels to search: FTA, Scrambled, ALL
or Network.
Start searching for TV and radio channels using the above
settings. Press the RED button.
TV and radio broadcast channels will be searched.
The names of the channels will be listed.
Press the EXIT button to return to viewing mode and check
whether the reception of the selected channel is good.
Note on Network Search:
In this search mode, the receiver first collects the network information first from the TP you
selected. Then an Auto Search takes place to research all the channels in that network. The
number of searched channels may vary, depending on the TPs present in that network. Select
whether to use the network information of the TP stream specified in "Select Transponder". I.e,
download the TP information of the satellite you want to find from a particular TP and then use
this to Auto Search the channels in the TP group. The number of channels searched may vary
depending on the TP information transmitted. Select Network Search and then use the
buttons to set it.
9.7 Manual Search Function
Use this channel search by entering the TP information manually to the receiver. This channel
search is often used to search for a particular channel or those channels that "Auto Search" has
missed, but it requires comparatively more expertise.
Select "Manual Search" and then press the OK button.
Select the satellite you want to track.
Set the LNB information and DiSEqC information for the
satellite. You can use the existing setting. To change the
setting, use the buttons.
Set the LNB polarization of the TP to "Horizontal" or
"Vertical".
After the settings are completed, select "Next" and then
press the OK button.
Set the Down Frequency of the TP.
Set the Symbol Rate of the TP.
Select the type of channels to search: FTA, Scrambled, ALL or Network.
Press the OK button to start searching using the above settings.
Another search method is "Advanced Search". Use this channel search to search for a
particular channel or channels ones that you couldn't find using "Manual Search". Enter the
PID of the channel you want to search.