Operation Manual

The software version is updated by downloading the new
software via the satellite. Prerequisite for this is that a more
up-to-date version is available.
Press OK and enter password.
The Software Update menu appears.
All transponder receiving data are preset by default.
All LNB / DiSEqC data are also preset, but can be
changed, if necessary.
Select "Air Down Load Start" and press OK.
A message is displayed saying
"Software Update in Progress ..."
The receiver first checks whether a more up-to-date
software version is available.
If not, "No available software found! Please try again later
on" is displayed.
After successfully downloading a new software version
"Software update completed!!!" is displayed and the
receiver automatically restarts.
Software update through PC
For carrying out this method you need to have the latest software file as well as a special
"loader" software for your PC.
It will be available by download from TRIAX website
www.triax.com Please check availability.
GB
9.11 Factory Preset
Go to the Main Menu and select "Channel Manager" and select "Reinstallation".
Enter password upon request.
A warning message appears. Press "EXIT" to cancel or OK to confirm.
The "Welcome" screen appears. Make your language selection and press OK.
Follow the instructions on the screen: either load pre-programmed channel data or start your
individual channel search process.
This function will delete all channel data and all individual settings from the receiver. The pre-
programmed channel data will be loaded again, and all settings will be reset to their default
values.
9.12 Software Update
If required, the latest development of the receiver operating software can be loaded to this unit
by software update. There are two kinds of software update procedures: Software update
through satellite (ASTRA 19
o
EAST). This method is also known as "OTA" ("On The Air"). Also,
there is a method of Software update through PC, using the RS-232 data interface on the rear
side of this unit.
Software update through Satellite
Go to the Main Menu and select "System Information".
Use this to check the software version or release date of
the current software before upgrading. System information
screen offers date, software version, and firmware.
DVB S1