Brochure
CoMpRession FiTTinGs
www.tribalmfg.com | 23
Information
Tribal brass compression ttings are ideal for use with copper,
brass, aluminum or plastic tubing and are commonly used
on gasoline, grease, oil, water, vacuum and air lines. Tribal
compression ttings are not recomended for use with steel
tube. Tribal oers a wide variety of compression ttings
including our Ander-Lign/Poly® universal compression ttings
with brass inserts.
The Ander-Lign/Poly universal compression ttings is the only
brass compression tting that can be used with almost any
type of tubing. The Ander-Lign/Poly universal compression
ttings come completely assembled with the brass insert and
captive sleeve. The bodies are interchangeable with standard
compression ttings. The Ander-Lign tting puts 360° of even
pressure on the tubing, ensuring a tight seal.
Specications
Temperature: -65°F to 250°F
Working Pressure: Temperature and type of tubing must be considered for proper tting selection. The following is based on 70°F with
copper tube.
Installation Instructions
Cut tubing square on the end. Start tubing on the insert side
and slide into the tting until it hits the stop. Wrench tighten
approximately 1-1/2 to 2 turns beyond hand tight. Do not
over tighten.
Made in the USA.
CoppeR TUBe o.d. TUBe Wall inCHes pse (andeR-liGn) pse (sTandaRd)
1/8" 0.030 2800 400
3/16" 0.030 1900 400
1/4" 0.030 1400 300
5/16" 0.032 1200 300
3/8" 0.032 900 200
1/2" 0.032 700 200
5/8" 0.035 640 150
3/4" 0.035 550 100
7/8" 0.035 450 75
THREAD SIZES
FiTTinG THRead siZe
1/8" 5/16" X 24
3/16" 3/8" X 24
1/4" 7/16" X 24
5/16" 1/2" X 24
3/8" 9/16" X 24
7/16" 5/8" X 24
1/2" 11/16" X 20
5/8" 13/16" X 18
3/4" 1" X 18
7/8" 11/8" X 18
Tube
Tubing
Nut
Insert
Thread
Compression Body
Sleeve
Nut and Sleeve