Brochure
FlaRe FiTTinGs
34 | www.tribalmfg.com
THREAD SIZES
FiTTinG 45º and inVeRTed pol Gas Fine THRead
1/8" 5/16" X 24
3/16" 3/8" X 24
1/4" 7/16" X 24 .88014LHT X 1/4"F 9/16" x 24
5/16" 1/2" X 24
3/8" 9/16" X 24 .88014LHT X 3/8"F 9/16" x 24
7/16" 5/8" X 24
1/2" 11/16" X 20 .88014LHT X 1/2"F 15/16" X 1/2"
5/8" 7/8" X 18 15/16" X 5/8"
3/4" 1" X 18 15/16" X 3/4"
7/8" 11/8" X 18
CoppeR TUBe o.d. TUBe Wall inCHes pse (FlaRe FiTTinGs)
1/8" 0.030 2800
3/16" 0.030 1900
1/4" 0.030 1400
5/16" 0.032 1200
3/8" 0.032 900
1/2" 0.032 700
5/8" 0.035 640
3/4" 0.035 550
7/8" 0.035 450
Information
Tribal oers a wide variety of are ttings including Standard
45°, Inverted 45°, POL, Gas Range, and Fine Thread (9⁄16" x 24)
for space heater applications.
Flare ttings are designed for higher pressure applications and
are commonly used for gasoline, grease, oil, water, vacuum,
air lines, L.P. and natural gas. Flare ttings can also be used for
refrigeration, air conditioning and other applications involving
hard-to-hold liquids and gases using forged nuts.
Recommended for use with copper, brass, aluminum
and welded steel hydraulic tubing that can be ared. Not
recommended for use with polybutylene or soft plastic tubing.
Specications
Temperature: -65°F to 250°F
Working Pressure: Temperature and type of tubing must be considered for proper tting selection.
The tables below are based on 70°F with copper tube. POL and Gas Fittings have a maximum working pressure of 250 psi.
Installation Instructions
Cut tubing square and put nut onto tubing. Flare tubing with
45º aring tool and hand tighten nut over are and onto tting
body. Wrench tighten for positive metal-to-metal seal. Do not
over tighten.
Tube Nut FittingFlare