Use and Care Manual

two compartments and to effectively distribute the heated air evenly and

accurately.

8. MODE button will allow you to choose the mode of daytime or nighttime operation. Even

though the Sedona is very quiet with the daytime mode setting, nighttime mode will make

even less noise.

More Tips:

• The noise from the fan and wind flow will be reduced because the fan spins

slower when it is in nighttime mode. Consequently, the dehydration rate of

the nighttime mode will be a bit slower than that of the daytime mode.

• The basic setting of Sedona is daytime mode, and it will go back to daytime mode

when you turn the switch off.

9. START/PAUSE button is to restart or pause the operation. While Sedona is in operation,

if you open the door, the power supply to both the heating coil and the fan will be cut-off.

Sedona will automatically restart as soon as the door is closed.

More Tips:

• You will hear a buzzing sound when the buttons are pressed, when the door is

opened, and when the assigned time is over.

• To change the temperature and/or operation hours while the Sedona is running,

press the START/PAUSE button, then press the SET button and change the

temperature and/or time. Then press START/PAUSE button to re-start the Sedona.

NOTE: Sedona can be used to dehydrate up to 4 trays of food for smaller batches of dehy-

drated foods.

1. Insert the solid tray in the middle slot to divide the Sedona into two 4 tray dehydrators.

Since Sedona is equipped with two independent fans with heating coils, Sedona can be

used to dehydrate foods in the upper and lower half of the unit when divided. .

2. Press the TRAY button to select which fan with heating coil will be active.

3. Load the trays into the chosen half of Sedona according to which fan with heating coil

is selected.

More Tips:

• If you choose one half, power supply to both the heating coil and fan of the other

half will be shut off.

• If you choose upper half, you may dehydrate up to 5 trays including the solid tray

(the divider). The upper LED will be on.

• Using the upper half of the machine is recommended if you wish to operate one

half of the machine because heat naturally rises.

• If you choose lower half, you may dehydrate up to 4 trays. The lower LED will be on.

• If you see both LEDs are on, it means that you chose both upper and lower halves

(the whole system). Try again to choose proper half.