Use and Care Manual

OPERATION

For your safety and to protect your Sedona, please follow the instructions below.

1. Always keep the Sedona on a leveled surface.

• Keep Sedona at least 10 cm away from other appliances or furniture.

2. Place food on each tray as the instruction manual book explains.

• Cut the food into even slices.

• Use one tray for each type of food. Do not cross contaminate.

• Lay the food in rows on the food tray with at least a one inch gap in between

each slice of food so that each piece does not overlap onto the next.

• You may dehydrate up to 9 trays simultaneously.

• For 4-5 trays of dehydrated recipes, please use the upper compartment for

best results.

3. Open the door to insert trays into the Sedona. Hold the tray in the horizontal position and

push the tray into the proper slots.

• Please double check whether all the trays are properly loaded.

4. Plug in to an outlet that has 10-amp capacity.

5. Turn the main switch ON.

6. Set the temperature and time. Press the Start/Pause button.

• Please refer to Set-Up page.

• Sedona will automatically switch to stand-by mode after the drying time has

expired. Also, a buzzard will sound when the drying time has expired.

• Turn the main switch OFF after finishing dehydration.

7. Sedona is designed to evenly distribute warm air from the rear to the front of the unit.

Depending on the climate and temperature of the air flowing into the unit from the rear, there

may be a slight difference in temperature between the trays and inside the drying compart-

ment. Because heat rises naturally, it is normal for the top trays to be exposed to more heat

than the trays in the center or on the bottom. For best results, rotate the trays periodically.