Use and Care Manual
8
SET-UP
Function of switch and buttons:
1. POWER Switch is to turn on or off the Sedona.
2. °F/°C button will enable you to select a temperature display mode (Celsius or Fahrenheit).
Select which temperature mode you want to display by pressing °F/°C button.
The basic setting of Sedona is Celsius when out of the factory. Once you set the machine
to Celsius or Fahrenheit, the Sedona will remember your setting even after you turn OFF the
switch.
3. Temp This window is used for two separate functions.
Please note during operation, the Temperature Display will display your desired temperature
setting, and NOT of the actual temperature of the drying compartments.
A. Setting Desired Temperature (Set Up)- During set up this window will be used
to set the desired temperature of the drying compartment.
a. The drying compartment temperature usually does not go over the
temperature you set.
b. The condition of the inflowing air may adversely affect the actual
compartment temperature. The actual compartment temperature may
read a +/- 3° difference. The difference is registered by the thermal
sensor, thus regulating the heating coil activity.
B. Temperature Display- Will display your desired temperature setting
a. The 2 glyphs on the far left of the TEMP display indicate which of the
two heating coils is active at any given time.
b. When the top left glyph is lit, the top heating coil is active.
c. When the bottom left glyph is lit, the lower heating coil is active.
d. When the two glyphs light up alternately, both heating coils are
active.
*Attention: While the temperature displayed by the Temperature Display is the set desired
temperature, actual temperatures in the drying chamber may fluctuate up to ±3°C
4. TIMER window will show the desired hours during set-up the Sedona. It will also show
the remaining hours during operation.
More Tips:
• When the dot located right next to the lower portion of the time display is blinking,
the timer is on and the machine is working.
• If the dot is not lit, the timer has stopped. This means that the machine has
stopped/paused all functions. Press START button to turn the programmed set-
tings of the machine and the timer on and resume operation. Please follow the set
up instructions to reset or change to new desired settings.