Use and Care Manual

5. SET button will enable you to set the temperature and the time. If you press the SET but-

ton once, the 3 digit TEMP window will flash. If you press the SET button once more, the 2

digit TIMER window will flash.

(1) Press the SET button once – While the TEMP widow flashes, set the desired temperature

by using the 10 or 1 buttons to select your desired temperature. When the TEMP window

displays your desired temperature, press the SET button to finalize your temperature setting.

Your desired temperature is now set up, and the TIMER window will flash.

(2) Press the SET button twice - While the TIMER window flashes, set the desired hours by

using the 10 or 1 buttons to select the desired timer setting, then press the SET button after

you have set the timer to your desired setting to finalize your choice.

More Tips:

• The stand-by time is 5 seconds. If you do not begin to set the temperature or

timer setting within 5 seconds, the set-up mode will be cancelled.

• For faster and accurate setting of temperature and time, Sedona has 2 sepa

rate buttons of 10 and 1. The buttons under the 10 represent increments of

ten whereas the buttons under the 1 represent increments of one.

• You may set the dehydrating time up to 99 hours.

• Sedona has a continuous dehydration function which allows you to continuously

dehydrate for more than 99 hours,. To enable this function, press and hold the

10 up button until CO is displayed. The CO function will dehydrate for a

maximum of 150 hours.

• The basic setting of Sedona is 45°C, 10 hours when out of factory. 45°C is

equivalent to 113°F.

• Sedona will save your settings for next use even though you turn it off.

6. UP/DOWN (10,1) buttons are for setting the temperature or the hours for the timer - one

short press will change the number by 1, and the number will be continuously changed

when the button is pressed for more than 1 second.

7. TRAY button is used to select which compartments will be activated. You can choose to

dehydrate up to 9 trays of foods or up to 4 trays of food in either the upper half or the lower

half of the unit. Sedona is designed to operate the whole unit or only operate the upper half

or only operate the lower half in order to conserve energy when dehydrating smaller quanti-

ties of food.

More Tips:

• The basic setting of Sedona is whole (Upper half + Lower half) when out of

factory.

• The Sedona will not remember your setting, and it will go back to whole when

you turn the Sedona off.

• Due to energy effectiveness, we recommend using the upper half only when

drying up to 4 trays. Please use the tray divider to separate the machine into