Vertical Slow Juicer SJV-107 OPERATION MANUAL Please read this manual carefully before using
TABLE OF CONTENTS 1. GENERAL SAFETY REGULATIONS 1. General Safety Regulations ...................................................................................3 Special Notice: To ensure the safe usage of this machine and to avoid injury and property damage to you and to others, please read this instruction manual carefully and follow all of the safety warnings and precautions. Failure to follow the safety warnings may lead to accidental injury or damage.
2. PRODUCT INTRODUCTION 3. HOW TO ASSEMBLE Components Name & Function q r u i w o 1. Attach the Auger Housing Align the “•” mark on the Auger Housing with the “ ” mark on the Main Body, then rotate clockwise so that the “•” mark is aligned with the “ ” mark. 4. Attach the Feeding Chute Align the “•” mark on the Feeding Chute with the “ ” mark on the Auger Housing, then rotate clockwise so that the “•” mark is aligned with the “ ” mark.
. USING THE SLOW JUICER Please thoroughly clean all non-electrical parts with soap and water before using the juicer for the first time. Use a damp cloth or sponge to clean the Main Body. Do not submerge or use running water to clean the Main Body. The juicer has a built-in safety switch that will prevent the juicer from operating unless all the parts are assembled correctly. Power Switch: ON: Press the top portion of the Power Switch to the ON position to start the motor.
6. CLEANING AND MAINTENANCE 1. Clean the following parts with soap and running water. These parts may be soaked for easier cleaning. Use both ends of the Brush to thoroughly clean and remove any left over pulp. 7. BEFORE USING Precaution Reason Do not use ice. Ice can get harder when it is squeezed and damage the juicing parts. Do not use hard or dried food. Certain hard or dried foods can damage the juicing parts.
8. TROUBLESHOOTING The motor does not turn on. • Check that the power cord is plugged into a working socket. • Check that all parts have been assembled correctly. • Contact your customer service center. Trouble removing the Feeding Chute. • Check whether there is a lot of pulp in the Auger Housing. If so, turn the juicer on to remove the excess pulp. • Check whether there is any hard objects stuck in the Feeding Chute. The REV button may help dislodge it. • Contact your customer service center.
Tribest Corporation 1143 N. Patt St., Anaheim, CA 92801 toll free: 888-254-7336 | tel: 714-879-7150 www.tribest.com | service@tribest.
