Use and Care Manual

3. Remove the Juicing

Screen

Pull the Juicing Screen

straight up and out of the

Auger Housing.

4. Remove the Auger

Housing

Rotate the Auger Housing

counterclockwise until the

“

•

” mark is aligned with the

“ ” mark on the Main

Body. Remove the Auger

Housing by pulling upwards.

5. HOW TO DISASSEMBLE

1. Remove Feeding Chute

Rotate the Feeding Chute

counterclockwise until the

“

•

” mark is aligned with

the “ ” mark.

Remove the Feeding Chute

by pulling upwards.

2. Remove Auger

Pull the Auger straight

up and out of the Juicing

Screen and Auger Housing.

4. USING THE SLOW JUICER

Please thoroughly clean all non-electrical parts with soap and water before using the

juicer for the first time. Use a damp cloth or sponge to clean the Main Body. Do not

submerge or use running water to clean the Main Body.

The juicer has a built-in safety switch that will prevent the juicer from operating unless

all the parts are assembled correctly.

Power Switch:

ON: Press the top portion of the Power Switch to the ON position to start the motor.

Press the bottom portion of the Power Switch to turn off the motor.

REV: Press and hold the bottom portion of the Power Switch in the REV position to run

the motor in reverse. This is helpful to clear out any hard produce that may cause the

juicer to stop.