Visor Cooker Hood - CH 520 and CH 610 Operating and Installation Instructions
CONTENTS Please refer to the sections in this booklet that apply to your particular model: CONTENTS WARNINGS GENERAL INSTALLATION INSTRUCTIONS OPERATING INSTRUCTIONS DO’S AND DON’TS MAINTENANCE AND CLEANING MAINTENANCE AND CLEANING HELP US TO HELP YOU Page 1 2 3 4 5 5 5 6 6 7 7 8 8 9 ELECTRICAL CONNECTION UNPACKING POSITIONING WALL FITTING WALL CABINET FITTING DUCTING FITTING WORKTOP LIGHTING FILTERS TECHNICAL SPECIFICATIONS DIMENSIONS CH520 CH610 Width Width Height Depth Depth with visor open cm cm
WARNINGS WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings.
GENERAL INFORMATION ELECTRICAL CONNECTION This instruction book applies to the following models: Before connecting to the mains supply ensure that the mains voltage corresponds to the voltage on the rating plate inside the cooker hood. Tricity Tricity Tricity Tricity Bendix Bendix Bendix Bendix CH520B CH520W CH610B CH610W Brown White Brown White 50cm 50cm 60cm 60cm This cooker hood is guaranteed and will give lasting service.
INSTALLATION INSTALLATION UNPACKING brackets. The hood must not be fitted using the key hole fixing points but with the special brackets supplied. Use the paper template provided to mark the hole positions on the wall for the bracket fixing screws. Check the hole distances are correct with a tape measure as stated on the template.
INSTALLATION Cont’d OPERATING INSTRUCTIONS WALL CABINET FITTING The cooker hood functions are controlled by two slide switches and a change-over slider control. The two slide switches, which are located on the right hand side in the front fascia panel, control the fan speed and worktop illumination. The change-over slider control is located inside the hood behind the inlet grille immediately in front of the lamp assembly. Ensure the hood is in, or wired in and the power supply is switched on.
MAINTENANCE MAINTENANCE DISCONNECT THE HOOD FROM THE MAINS SUPPLY BEFORE CARRYING OUT ANY KIND OF MAINTENANCE OR CLEANING. WORKTOP LIGHTING If a lamp fails to function at any time first check that it is fully screwed into the holder. When changing the lamp an identical replacement must be fitted to ensure the safe working of the cooker hood. Replacement lamps are specified 230-240Volts 40Watt clear cylindrical, candle, or tulip shape with small Edison (E14) screw thread cap.
HELP US TO HELP YOU HELP US TO HELP YOU Please determine your type of enquiry before writing or telephoning. BEFORE CALLING ENGINEER SERVICE In the event of your appliance requiring service, Tricity Bendix have an arrangement with Electrolux Group Service. Before calling out an engineer, please ensure you have read the details under the heading ‘Before Calling a Service Engineer’ and have the model number and purchase date to hand.
Rating Plate The rating plate is situated inside the casing on the back panel. It gives the MODEL AND SERIAL NUMBER, which should be quoted in any communication or if the service department is contacted. It is advisable to make a note of these below and keep for reference before the appliance is installed. MAKE AND MODEL NO. SERIAL NO.
