CONTENTS Please refer to the sections in this bookie that apply 1o your particular model: Page Contents Technical Specifications Warnings... General Information .. Electrical Connection Unpacking Positioning Installation Wall FISHING w..rernimin. Installation Wall Cabinet Fitting Installation Ducting Fitting Operating Instructions. Maintenance and Cleaning Charcoal Fitter Grease Filter Do’s and Don'ts.. Help Us To Help You .. Customer Care Department ..
WARNINGS WARNINGS Cont'd It is most important that this instruction book should be retained with the appliance for future reference.
GENERAL INFORMATION ELECTRICAL CONNECTION This instruction book .applies to the following models: Trinity Bendix CH8058 Brown 60cm Trinity Bendix CHEW White 60cm This cooker hood is guaranteed and will give fasting service.
INSTALLATION INSTALLATION Cont'd Unpacking Care should be taken when unpacking the cooker hood to ensure that the fixing kit, ducting spigot, blanking plate and Literature pack are retained with the hood.
INSTALLATION Cont'd DUCTING FITTING The wall brackets have two studs and when the wooer hood is hung onto the brackets the studs project through the two holes above the leveling screws. When the hood is level fit the two shake proof washers and nuts supplied to fully secure the cooker hood. Wall Cabinet Titling Before fitting the cooker hood beneath any type of wall cabinet ensure it is firmly fixed to the wall in accordance with the manufacturers instructions.
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS Cont'd The cooker hood functions are controlled by twa slide switches and a change-over slider control. The two slide switches, which are located on the right hand side in the front fascia panel, control the fan speed and worktop illumination. The change-over snider control is located inside the cooker hood behind the inlet grille immediately in front of the lamp assembly. Engineer the hood Is plugged in, or wired in and the power supply is switched on.
MAINTENANCE MAINTENANCE Cont'd DISCONNECT THE HOOD FROM THE MAINS SUPPLY BEFORE CARRYING OUT ANY KIND OF MAINTENANCE OR CLEANING. Worktop Lighting if & lamp fails to function at any time first check that it is fully screwed into the hider. When changing the lamp an identical replacement must be fitted to ensure the safe working of the cooker hood. Replacement lamps are specified 230-volts Ad Watt clear cylindrical, candle, or tulip shape with small Edison (E14) screw thread cap.
Rating Plate The rating plate is situated inside the casing on the back panel. It gives the MODEL AND SERIAL NUMBER, which should be quoted in any communication or if the service department is contacted. it is advisable o make a note of these below and keep for reference before the appliance is installed. MAKE AND MODEL NO. SERIAL NO.
