TRINITY BENDIX e Better Products. Better Value.
WARNINGS WARNINGS Cont'd it is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred io another owner, or should you move house and slave the appliance always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings.
GENERAL. INFORMATION ELECTRICAL CONNECTION This instruction book applies to the following modest; Trinity Bendix CH6508 Brown 60cm Trinity Bendix CHEW White 80cm This ocker hood is guaranteed and will give lasting service. The guarantee is only applicable if the hood has been installed in accordance with the installation instructions detailed in this booklet.
INSTALLATION INSTALLATION Cont'd Unpacking Care should be taken when unpacking the cooker hood 1o ensure that the fixing ki, ducting spigot and literature pack are retained with the hood. The fixing kit comprises: 2 Wall fixing brackets 4 Plastic raw plugs 4 Fixing screws 8 Decor panel fixing screws 4 Security fixing screws Positioning When positioned above: an electric cooking appliance the minimum distance between the surface of the hob elements and the lower grille of the hood must be 65¢m (261/2ins).
FITTING THE DECOR PANEL DUCTING FITTING To fit the decor panel onto the hood, it is necessary to remove the complete visor assembly from the hood. To remove the visor, pull open the visor into the operating position, and while pressing down on the release catch located behind the visor on the deft hand side of the casing, remove the visor. The decor panel should be fetid in accordance with the template instructions using the & x 13mm {1/2ins) round headed screws provided.
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS Cont'd The cooker hood functions are controlled by three slide switches, an automatic micro switch and a change-over slider control. The three slide switches are located on the right hand side of the hood casing immediately behind the visor as illustrated in fig. 4. The three slide switches control the worktop lighting and the fan speed.
MAINTENANCE MAINTENANCE Cont'd DISCONNECT THE HOOD FROM THE MAINS SUPPLY BEFORE CARRYING OUT ANY KIND OF MAINTENANCE 'OR CLEANING, Worktop Lighting If a tamp fails to function at any time first sack that it is fully screwed into the holder. When changing the lamp an identical replacement must be fitted to ensure the safe working of the cooker hood. Replacement damps are specified 230-introits Watt clear cylindrical, candle, or tulip shape with small Edison (E14) screw thread cap.
Rating Plate The rating plate is situated inside the casing on the back panel. It gives the MODEL AND SERIAL NUMBER, which should be quoted in any communication or if the service department is contacted. 1t is advisable to make a note of these below and keep for reference before the appliance is installed. MAKE AND MODEL NO. SERIAL NO.
