User manual

30
Technical details
Voltage: 230-240 Volts AC 50Hz
Wattage: 10.9 - 11.8kW
Height: 900mm
Width: 600mm
Depth: 598mm
Weight: 65 kg
This appliance complies with: European
Council Directives 73/23/EEC. EMC
Directive 89/336/EEC, CE Marking
Directive 93/68/EEC. Energy Label
Directive 2002/40/EC
Installation instructions
Warning: This appliance must be
earthed.
If your appliance has been damaged in
transit, contact your supplier immediately.
DO NOT attempt to install it.
Your appliance left the factory fully packaged
to protect it from damage. If it is delivered
without packaging and damage has
occurred, the manufacturer cannot accept
responsibility. Contact your supplier for
advice.
Once the packaging has been removed the
appliance should only be moved by hand.
DO NOT use a sack barrow or any other aid
to lift the appliance as damage may occur.
Connection to the electricity supply must be
carried out by a qualified
electrician/competent person.
The electrical connection should be made
using a double pole isolating switch (cooker
socket) with at least 3mm contact separation
in all poles. The cable must have
conductors of sufficiently high cross-
sectional area to prevent overheating and
deterioration.
The recommended cross-section area is six
square millimetres (6.00mm
2
).
The cable should be routed away from
potentially hot areas marked by X. See
Fig.1.
To move the appliance, open the oven door,
and lift the appliance by holding inside the
top of the compartment. See Fig.2.
This is a type Y appliance, which means it is
free-standing and can be fitted with cabinets
on one or both sides. It may also be fitted in
a corner setting.
Side walls which are above hob level should
be protected by heat resistant non-
combustible material and MUST NOT be
nearer than 40mm to the hob side.
A nominal air gap of 2mm at either side of
the appliance is required to enable the
appliance to be moved into position.
Fig.2.
Fig.1.