WARNINGS IT 1S MOST IMPORTANT THAT THIS INSTRUCTION BOOK SHOULD BE RETAINED WITH THE APPLIANCE FOR FUTURE REFERENCE. SHOULD THE APPLIANCE BE SOLD OR TRANSFERRED TO ANOTHER OWNER, OR SHOULD YOU MOVE HOUSE AND LEAVE THE APPLIANCE, ALWAYS ENSURE THAT THE BOOK IS SUPPLIED WITH THE APPLIANCE IN ORDER THAT THE NEW OWNER CAN BE ACQUAINTED WITH THE FUNCTIONING OF THE APPLIANCE AND THE RELEVANT WARNINGS. These warnings are provided in the interest of safety.
CONTENTS Warnings Contents Technical Specifications General advice Positioning and Installation Care and cleaning Using your machine How to load the dishwasher Test the machine by running a cycle Maintenance and cleaning Servicing Twelve months guarantee After sales Service Service Center Dresses TECHNICAL SPECIFICATIONS Capacity: Dimensions: Weight: ELECTRICITY Voltage: Fuse: Mains lead: Rating heating element: Total: WATER SUPPLY Water pressure: Temperature: 4 (standard IEC place settings) + 4 cups Width
GENERAL ADVICE Remove all packaging before positioning the machine. Check that the following accessories are supplied with the dishwasher when you unpack it: « Inlet hose (1) « Discharge hose (2) « Hose ¢lip (3} for discharge hose on dishwasher. .
POSITIONING AND INSTALLATION The dishwasher is intended for installation on a kitchen sink or worktop. It is important to ensure the dishwasher is level to avoid any difficulty opening and closing the door. its height can be adjusted with the adjustable feet (8 mm each) in each corner of the dishwasher. WATER SUPPLY The dishwasher should be permanently plumbed into a separate hot or cold water supply. A kit can be purchased from any good plumbers’ merchants, or your local Trinity Bendix Service Center.
DISCHARGE CONNECTION The Grey discharge hose should be permanently plumbed in. i this is not possible, it can be placed in the sink to drain. Don't forget that the water will come out with some force, so position the pipe so that the force of the water will not push the hose out of the sink. Ensure the sink outlet is not blocked. Connect the discharge hose to the pipe stub at the rear of the dishwasher, using the hose clip supplied.
GREEN & YELLOW 13 AMP FUSE CORD CLAMP ELECTRICAL CONNECTION WARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted. Remove the fuse from the cut off plug.
RINSE AID DISPENSER (1) Use of rinse aid will result in faster drying of the load and gives the dishes shiny finish. it may be necessary to adjust the quantity of rinse aid dispensed if you live in either a very hard water or a very soft water area. Org is needed for hard water and less for soft water.
Proceed as follows: * Fill up with water(only the first time) and afterwards with coarse dishwasher salt. Ordinary domestic salt will affect the efficiency of the water softener and damage it. Use the funner! supplied with the dishwasher. Water wiki come out of the container as you fill with sat. This is normal. You will need about 1.3 kg of salt fo start with, you should see the level of salt near the top of the container. This is enough for about 20 30 dish washing cycles.
USING YOUR MACHINE Approximate consumption levels of electricity and water are given in the following table. CONSUMPTION PER CYCLE SETTING Cold water supply at 15°C | Hot water supply at 60°C ) Cycle temperature.
HOW TO LOAD THE DISHWASHER The illustration shows the machine loaded with four standard place settings. Your own dishes are not likely to be identical to this load, but if you follow the advice below we are sure you will be pleased with the results, * Always place glasses, cups and bows upside down. * Incline deep dishes (soup plates etc.} so that the water can run off when drying. » Make sure that the dishes do not rest against each other.
TEST THE MACHINE BY RUNNING A CYCLE 1 Scrape off solid food remnants. 2. Load the dishwasher. (See page 16: “How to load the dishwasher. Pour approx 15 g detergent into the detergent compartment inside the door, If the dishes are normally or heavenly soled add an extra 5 g anywhere on the inside of the door. Close the door. 3 3. Plug in the dishwasher Start the dishwasher by muting the programmer knob to the *On” position. 4.
MAINTENANCE AND CLEANING important Make sure that the machine is unplugged and the water muted off before undertaking any kind of maintenance. General cleaning Inspect the filters and spray arm nozzle before reloading the machine and remove any food scraps. Wipe round the rubber gasket at the bottom of the door to remove grease which tends to collect there. Cleaning the filters There are two filters, a coarse one and a fine one which should be cleaned after every wash.
SERVICING Certain problems are due to frack of simple maintenance or oversights and can be solved easily without having to call out an engineer. The machine will not start « The door has not been properly closed. « The plug is not properly inserted in the power socket. + There is no current at the socket. Check the fuse.
TWELVE MONTHS GUARANTEE Trinity Bendix guarantee conditions This guarantee is in addition to your statutory and other legal rights which will not be excluded or in any way diminished by the return of this guarantee card. We, Trinity Bendix.