0 NYX vy TRINITY MODEL 816 B/W DISHWASHER User and installation constructions CONTENTS General advice Unpacking, transit damage Description 2 Get to know your dishwasher How to run an ordinary dish washing programmer Table of programmed Dishwasher detergents and rinse conditioners Loading's the dishwasher and useful information 5 Water softener for hard water 6 Care and cleaning BORN 5 Safety What fault occurs Guarantees, service, spare parts How to install the dishwasher 8-10 Technical data 10 822 29 12001
General advice on dish washing and the use of your dishwasher The is‘designed for washing household utensils only. UNPACKING Inspect the product to ensure that it Is undamaged. TRANSIT DAMAGE Damage sustained in transit must be reported within seven days to whoever is responsible to transpiration. First read the instructions carefully. Then you will know how to use and look . after your dishwasher in the tight way. DESCRIPTION {See general illustration on the facing page) Control panel 1. Stan 2.
How to use and oak after your dishwasher Running the Normal wash cycle. summary of operations. Open the door and withdraw the racks. if necessary, Sift out the cutlery basket. Scrape or tines off larger quantities of food remnants therefrom dishes, and inert 1 ‘racks. Contents | 3. Place cutlery in the cutlery basket and put it in the front of the lower rack. Side the racks into the dishes dishwasher. Add detergent (and rinse conditioner, Do not forget to close the dispenser lid. 4, Close the door. 5.
upper rickrack) The upper rack is used for cups, saucers, glassware, bowls, long knives, spatulas etc. Place cups and glassware in the rack upside down. Tilt deep dishes so that the water can drain off easily. The extra cup rack can be re positioned. ‘The upper rack can be raised or lowered in two positions to-make room for tall dishes in the. upper or lower rack. Proceed as follows: withdraw the rack as far as possible, bend aside the stops on the rails and withdraw the rack fully.
Water soften This dishwasher ha8 a special filter to soften excessively hard water using coarse cooking sat, When it Is time to replenish the salt a lamp wiki fight up on the control pane. 1. Unscrew the filler cap on the salt container and fill it with coarse cooking sat. Use the funnel supp(led with the dishwasher. 2. Clean the filler cap thoroughly inside and out _velvety time you fill the container with salt and apy.sutpiug salt round the filled opening. softener. 3.
SAFETY A switch in the door catch stops the machine if the door is opened. The dishwasher incorporates safety devices which clues the water valve and start the discharge pump if flooding occurs, 1. Overflow monitor, which operates if too much Walter enters the machine. 2. | Leakage monitor, which operates If water runs down onto the bottom of the machine. The monitor congests’ of a switch with a spring-located lever . pressing against a-dry sponge. If the sponge.
INSTALLATION ( See Figs. } in general First a few words about official regulations: Electrical, water supply and drainage installation should be carried out by persons who are qualified and authorized to do such work. if you do any installation work yourself ,.find out about the .relevant regulations and. .. follow them carefully. Installation work that is carried out Incorrectly may cause Injury to persons-and damage. to property.
. 35y The dishwasher is designed for under counter installation but may also be used as a stand alone appliance. In such € vent it must be secured so that it cannot tip forwards when the door is opened and dishes, etc. are placed obit. The side(s) aqd.top panel should then be fitted. IMPORTANT The dishwasher must be perfectly level in order to function satisfactorily. If it Is Inclined in any direction the wrong amount of water may be admitted and the door may also bo hard to close.
Water connection The temperature of the incoming water should not be higher than 70" C. Far connection to the water supply the machine is fitted with a 1.5 m long inlet hose of polythene with a 3/4* threaded fitting at the free end. No extra non-return valve or suction trap is required. At the rear is an installation zone with a height or 176 mm and a depth of 80 mm for the hoses and outside pipes. Drain connection Water discharge: Note: the inside diameter.of the hose.must not.be smaller than 18 mm.
