User manual

21
Care and cleaning
WARNING!
Before cleaning always allow the appliance
to cool down before switching off at the
electricity supply.
Cleaning materials
Before using any cleaning materials on your
appliance, check that they are suitable and that
their use is recommended by the manufacturer.
Cleaners that contain bleach should not be
used as they may dull the surface finishes.
Harsh abrasives and scourers should also be
avoided.
Cleaning the outside of the appliance
Do not use abrasive cleaning materials e.g.
abrasive cream cleaners, wire wool pads or
scourers on painted or printed finishes as
damage may occur. Regularly wipe over the
control panel, control knobs, handles, doors and
appliance sides using a soft cloth and hot soapy
water. To prevent streaking, finish with a soft
cloth.
Stainless Steel cream cleaners are abrasive
and should be avoided as they may dull the
surface finish. Any spillage on the stainless
steel finish must be wiped off immediately.
WARNING!
Do not attempt to remove any of the control
knobs from the appliance as this may cause
damage and is a safety hazard.
Removing and replacing the
wirework runners
Remove all shelves
and furniture from
the oven.
Hold the wirework
at the bottom,
unclip from the
cavity side and
gently pull towards
the centre of the
oven.
Unhook the runner
at the top and
remove from the
cavity.
To replace the
runners, hook the
wirework side runner into
the cavity, slide back and
press into place.
WARNING!
Ensure the wirework runners are firmly in
position before replacing the oven shelves.
Cleaning inside the grill and oven
compartments
• The vitreous enamel coating in the grill/top
oven and main oven compartments can be
cleaned using normal oven cleaners with
care. Ensure that the manufacturers
instructions are followed and that all parts
are well rinsed afterwards.