User manual

26
• Fit the appliance mounting brackets using
the two holes indicated to the adjacent
cabinets.
• Check that the mounting brackets are level.
They can be adjusted if necessary by using
the extra holes at the ends of the brackets.
Once the brackets are level, drill a pilot
hole through the central hole in the bracket
and fit the remaining screw.
How to finish unpacking
• Place packed appliance next to the space
in which it will be installed.
• Remove the appliance packing except for
bottom tray, which should be left in position
until the appliance is ready to be fitted into
its cabinet.
• NOTE: It is imperative that the
appliance is left in the base to protect
both the appliance and the floor.
• Ensure the user is given these operating
instructions.
WARNING!
Important: Switch off at the mains,
miniature circuit breaker and if appropriate,
remove fuse before commencing any
electrical work.
To remove cover of mains terminal
From the rear of the appliance, remove mains
input terminal cover to gain access to terminal
block.
• First remove retaining screw with pozidrive
screwdriver.
• Prise cover loose using screwdriver in
position (1) then lever off with screwdriver
in position (2) at either side.
• Lift cover and remove screw from cable
clamp.