User manual

2
8
• Take out all oven furniture before
installation to reduce the weight you need
to lift. The oven door should be taped to
keep it closed whilst lifting.
• To place the appliance into the space
between cabinetry follow the procedure
below:
IMPORTANT!
Two people will be required to carry out the
lifting procedure.
WARNING!
Warning: Do not attempt to lift this
appliance by the handle(s).
• Each person should squat either side of the
appliance.
• Tilt the appliance so that your hands can
support the underside of the appliance.
• Keeping your back straight raise the
appliance to the correct height by
straightening at the knees.
• Rest the rear underside of the appliance on
the mounting brackets while your hands
support the front.
• The appliance can be pushed fully into the
space. Take care to avoid fouling the mains
lead.
• Ensure the appliance is central and level.
• When the appliance is fully housed, screw
the stability screws (supplied with the
appliance) into the underside of the
worksurface in the positions indicated, taking
care not to distort the trim. It is advisable to
turn each screw alternatively to avoid
damaging the trim.
• Place the heat deflector flush with the edge
of the worksurface, with the cork spacers
up over and screw into position using the
screws supplied with the appliance. Failure
to do this may cause damage to the work
surface
• Replace the plinth board.
• Switch on the appliance and refer to the
operating instructions.