User manual

Fit the door in place on the hinge pin.

Refit the bottom hinge plate assembly on the

opposite side, taking care that the edge of the door

is parallel with the side of the cabinet.

Slot the hinge pin into the hole in the hinge plate

and relocate the hinge assembly to the opposite

location and refit using the retaining screws.

To reverse the handle proceed as follows:

Remove screw covers (if fitted) and handle retaining

screws. Remove blanking plugs on the opposite

side

using a punch

Relocate the handle to the opposite side and refit

retaining screws (covers if fitted), and

push the

plastic plugs supplied with the instruction book into

the holes where the handle was previously fitted