User's Manual

ManualsBrandsTrig Avionics ManualsElectronicsLicensed Non-Broadcast Aeronautical Transmitter

ENEN

Flip-Flop button puts the currently selected result into the active frequency

instead, and returns to the normal operating screen.

Recent Frequencies

Recent FrequenciesRecent Frequencies

Recent Frequencies

There is also a memory of the ten most recent frequencies that you have used.

From the initial memory screen, move the cursor using the large knob to

highlight the MEMORY caption, and turn the small knob to select the RECENT

database.

Move the highlight onto the frequency, and you can scroll through the ten

most recently used frequencies.

GPS Database

GPS DatabaseGPS Database

GPS Database

If it has been configured in your aircraft, there is a third database in the radio.

This is loaded by your GPS receiver and will contain airfields appropriate to

your current route of flight.

It is accessed exactly the same way as the built in database, except that you

first select the remote data source using the large knob (to highlight the

database field) and the small knob (to select the GPS data source).

The only difference is that airfield identifiers are usually ordered by how close

they are to your route, rather than alphabetical order.

Entering New Frequencies

Entering New FrequenciesEntering New Frequencies

Entering New Frequencies

You can add station identifiers and frequencies to the internal database, which

stores up to 250 entries. To edit the database, go into memory mode by

pressing the MEM button, then press and hold the MEM button for 5 seconds.

The screen will change to highlight the top field which will offer the choice of

EDIT, DELETE, ADD NEW and CANCEL.

ENEN

To add a new database entry, select ADD NEW, and then press MEM again.

Use the large knob to move the highlighted cursor, and use the small knob to

select characters, numbers or facility type. Pressing the MEM button again

stores the new value, and returns to the normal memory mode.

If you already have entries in the database, you can edit them to change the

details, or you can delete them. To do that, first find the entry that you want to

edit or delete using the normal memory mode. Then, with the entry you want

to change displayed, press and hold the MEM button for 5 seconds. The

choices described earlier will be offered; EDIT, DELETE, ADD NEW or CANCEL.

If you choose EDIT, and press MEM, the cursor can alter characters, numbers or

facility type in the current entry. Pressing MEM will save that changed entry. If

you choose DELETE, and press MEM, the current entry will be deleted.

If you get this far and realise that you did not want to change the database at

all, select CANCEL and then press MEM; you will be returned to the normal

memory mode.

Configuration Mode

Configuration ModeConfiguration Mode

Configuration Mode

Additional setup items can be accessed by holding down the MON button for

5 seconds. The menu options can be selected using the larger tuning knob and

the parameter value can be altered using the smaller tuning knob.

Intercom Volume Sets the intercom volume level

Intercom Squelch Sets the sensitivity of the intercom voice operated

squelch

Music Volume Sets the volume level of the music input

Music Muting Mutes the music audio when a VHF transmission is

received by the radio

Enable

8.33 kHz

Turns on or off the ability to tune 8.33 kHz stations. If