User's Manual

www.trilithic.com
www.trilithic.com
Page IV-25
802 AWE Operation Manual
Advanced Wireless Test Set
Ping Mode
When the Ping mode is selected, the following
measurement results are displayed as shown in
the image to the right:
• Minimum Time – This is the minimum
time required to send/receive a single test
packet.
• Average Time – This is the average time
required to send/receive all test packets.
• Maximum Time – This is the maximum
time required to send/receive a single test
packet.
• Sent – This is the number of packets sent by the 802 AWE to the destination IP
address.
• Received – This is the number of packets received by the 802 AWE from the
destination IP address.
• LPR – This is the lost packet ratio. This measurement is displayed in the bar graph
and as a numeric value. The LPR is calculated as the percentage of packets
received to those which were sent (LPR = {Received Packets / Sent Packets} *
100%), for example:
• 50 sent packets
• 25 received packets
• LPR = {25 / 50} * 100%
{0.50} * 100%
50%