User Manual

Trilliant, Inc. 1100 Island Drive, Suite 201 Redwood City, CA 94065 [phone] Page 2 of 3
INDUSTRY CANADA STATEMENTS
Operation is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
To reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted
for successful communication.
This device has been designed to operate with the antennas listed below
, and having a
maximum gain of 6.0 dB. Antennas not included in this list or having a gain greater than 6.0 dB
are strictly prohibited for use with this device. The required antenna impedance is 50 ohms. The
maximum gain antenna is the Mobile Mark OD6-2400 (6dbi gain).
Antennas Approved for use
Mobile Mark OD6-2400 (6dBi gain)
PCB Trace Inverted-L Antenna (1.1 dBi gain)
Trilliant Responsibilities to comply with FCC and Industry Canada Regulations
The SecureMesh 1 Watt Radio Module has been certified for integration into products only by a
professional under the following conditions:
1. The antenna(s) must be installed such that a minimum separation distance of 20cm is
maintained between the radiator (antenna) and all persons at all times.
2. The transmitter module must not be co-located or operating in conjunction with any other
antenna or transmitter.
As long as the two conditions above are met, further transmitter testing will not be required.
However, Trilliant is still responsible for testing their end-product for any additional compliance
requirements required with this module installed (for example, digital device emissions, PC
peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions cannot be met (for certain
configurations or co-location with another transmitter), then the FCC and Industry Canada
authorizations are no longer considered valid and the FCC ID and IC Certification Number
cannot be used on the final product. In these circumstances, Trilliant integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a
separate FCC and Industry Canada authorization.
End Product Labeling
The Trilliant SecureMesh 1 Watt Radio Module is labeled with its own FCC ID and IC Certification
Number. If the FCC ID and IC Certification Number are not visible when the module is installed inside
another device, then the outside of the device into which the module is installed must also display a
label referring to the enclosed module. In that case, the final end product must be labeled in a visible
area with the following:
“Contains Transmitter Module FCC ID: TMB-EM0069”
“Contains Transmitter Module IC: 6028A-EM0069