Installation Guide

SecureMesh
TM
Gateway Installation Guide
Trilliant Incorporated page 13 of 21
Streetlight Pole Mounting and Grounding
To install a Gateway on a streetlight, observe the following procedures:
Mounting the Device
Mount the Bracket
 Chose one of the two available Streetlight Installation
Kits from the Gateway accessory list. The kits vary only
in the length of the cable to attach to the streetlight
photo cell.
 If the clamp is not already separate from the main
bracket, remove the nuts from the bolts and separate
the clamp from the main bracket.
 Place the main bracket over the light pole’s horizontal
extension arm. Place the clamp on the bolts and
secure with the nuts provided as shown on the right.
Hand tighten the nuts.
 Make the mounting pipe plumb (straight) by moving the
main bracket from side to side and moving the plumb
adjustment bracket forward and backward. The
accuracy should be checked using a magnetic level.
When the mounting pipe is plumb, tighten all nuts.
photo cell tap
AC input
excess wire storage
clamp
Ethernet
PoE cable
power supply and
surge protection
plumb adjustment bracket
main bracket
mounting pipe
plumb adjustment screw