User's Manual

SKYPILOT NETWORK CONFIDENTIAL AND PROPRIETARY

Page

SKYPILOT NETWORK CONFIDENTIAL AND PROPRIETARY

3.2 Cabling

GW1000 and SD1000 both support Power over Ethernet (PoE) utilizing the Power

Injector provided. Note that the GW1000 and SD1000 units should be installed with the

SkyPilot provided Power Injector only. The use of other PoE Power Injectors could

result in damage to the unit.

Both units provide a 10/100bT connector and an RJ45 serial interface. The 10/100bT

Ethernet port provides interconnectivity for user and network traffic, while the serial port

is used for local access to the CLI. The photograph below shows the Ethernet port on the

right and the serial port to the left.

In order to ensure full weatherproofing, the grommet provided must be installed. The

Ethernet cable should first be connected and then pushed into the slit in the gasket and

then the gasket is pushed into the opening in the base. See the photograph below.