User's Manual

A
Accessing the Command-Line
Interface
This appendix describes how to access the command-line interface that SkyPilot
devices provide for provisioning and troubleshooting.
You can connect to a SkyConnector and access the command-line interface
through Telnet over an Ethernet connection. After logging in (by supplying a
password), you can enter commands at the command prompt.
1 Mount and cable the SkyConnector according to the instructions in
Chapter 3.
2 Prepare a PC or laptop.
Open the network settings panel and assign the computer the IP address
192.168.0.3 with a subnet mask of 255.255.255.0.
3 Connect the computer to the SkyConnector according to the instructions
in Chapter 3 (see “
Connect to a computer or LAN” on page 23).
4 Start a Telnet session.
Telnet to the default IP address of the SkyConnector (192.168.0.2).
5 Log in by entering the password at the command prompt. (The default is
public.)
SkyPilot SkyConnector Installation 25