User's Manual

SkyPilot SkyAccess DualBand Installation 30
To mount the SkyConnector:
1 Disconnect the CAT-5 cable from the power injector.
2 Power down the SkyConnector.
3 Attach a magnetic level to the 1 1/8" (2.87 cm) and 1 3/8" (3.48 cm)
diameter steel mounting pole to verify that the pole is plumb
(straight).
IMPORTANT It is the installer’s responsibility to verify that the support
pole and its installation method are of sufficient strength to
withstand onsite weather conditions. (The supplied
mounting bracket and screws are certified to withstand a
125 mph wind force.)
4 Use the provided clamps and screws (provided in the accessory kit)
to attach the SkyConnector to the mounting pole (see Figure 3-6).
Before clamping down the bracket, check that the mounting pole is
still plumb and that the SkyConnector is level.
NOTE If the device is not level, performance may be degraded.