User's Manual

Trilogik Technologies inc.
8061, rue Burgos,
Quebec (QC), Canada, G2C 0H3 V2.0, 2019-08-01
[e-mail]
www.trilogik.ca, [phone] 3
FCC and ISED Regulations
The MB001-A RF Module is licensed under the following numbers and rules:
FCC ID: 2ANOUTL
IC: 23199-TL
FCC 47 CFR Part 15 Subpart C, §15.247
Operation in the 902–928 MHz, 2400–2483.5 MHz, and 5725–5850 MHz
RSS-247, Issue 2, Feb 2017, Section 5
Digital Transmission Systems (DTSs), Frequency Hopping Systems (FHSs) and Licence-Exempt Local Area
Network (LE-LAN) Devices
Standard specifications for frequency hopping systems and digital transmission systems operating in the
bands 902–928 MHz, 2400–2483.5 MHz and 5725–5850 MHz
Note: host product manufacturers using this product are responsible for compliance to any other
FCC/ISED rules that apply to the host not covered by the above rules.
RF Exposure Considerations
This product complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment. To
comply with RF exposure requirements, the unit must be installed and operated with 20 cm (8 in.) or
more between the product and your body. This product may not be collocated or operated in conjunction
with any other antenna or transmitter. This device has been designed to operate with the antennas listed
below, and having a maximum gain of 2.0 dB. Antennas not included in this list or having a gain greater
than 4.5 dB are strictly prohibited for use with this device. The required antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful
communication.
The MB001-A is intended to be used without RF gain limitations but with one of the following antennas:
1/4 wave monopole antenna (4.5dBi) MFG: Trilogik PN: TLA001
1/4 wave monopole antenna (2.5dBi) MFG: Abracon PN: APAMS-131
1/2 wave dipole antenna (2.0dBi) MFG: Pulse Larsen PN: W1063
End Product Labelling Requirements
Any host product using MB001-A must have a label stating:
Contains FCC ID: 2ANOUTL, IC: 23199-TL
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interferences,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.