User's Manual

27
English
15. Check the LEDs on the Z-Max.Net front panel to make
sure the system is functioning correctly (refer to
page 4
to read the meaning of each LED). Typically, two LEDS
should blink green as shown opposite.
You can also monitor the Z-Max.Net rover from the
MobileMapper CE screen using FAST Survey’s
Equip
tab>
Monitor Skyplot function (see figure below).
Tap Back to return to the menu.
16. You can now let the base operate on its own and move on
to the rover configuration. Keep the field terminal on.
Also, keep FAST Survey running and leave the job open
as this is needed to configure the rover (see hereafter).
Configuring the RTK Rover
1. Tap on top of the screen
2. Tap on the name of the configuration corresponding to
the rover (e.g. “Z-Max Rover”) and then tap
Select. As a
result, FAST Survey automatically updates the settings in
the Comm Setup function to let you communicate with
the rover.
Current position
Computation
uncertainties
Number of
received satellites
GPS constellation
geometry