User's Manual

32
English
12.Tap OK. After a while, The GSM STATUS switches to
ONLINE (see screen opposite) and the Z-Max.Net
should start receiving corrections data. After a few
seconds the RTK Solution LED (far left) should blink
green meaning that the RTK position solution is fixed
and so you can start surveying.
13.Tap Close and proceed with the survey as such (see next
chapters).
You can monitor the Z-Max.Net rover from the field
terminal screen using FAST Survey’s
Equip tab>Monitor
Skyplot
function.
Saving Base and Rover Settings
When you configure your base or rover from FAST Survey,
a Save operation is automatically performed at the end of
the procedure and so you don’t need to save anything manu
-
ally.
After a power cycle, your base or rover will therefore con-
tinue to operate according to the last loaded configuration.
Running an RTK Survey
If you have followed all the instructions provided in this
RTK Surveying chapter, your rover is now fully configured
and so you can start your survey using your field-terminal-
controlled rover.
NOTE: To start the survey with the correct antenna height
when using FAST Survey, the rover should always have
been set up last.
The present section describes the main types of surveys you
can perform with FAST Survey and your Z-Max.Net,
namely:
- RTK point logging (Stop & Go survey)
- RTK point logging in continuous mode (trajectory sur-
vey)
- RTK staking out.