User's Manual
Table Of Contents
- 1. Introduction
- 2. Preparing For First-Time Use
- 3. RTK Surveying
- 4. Post-processing Surveying
- 5. Front Panel Interface Function Diagram
43
English
• Press the Enter key
• Enter the first character of the recording interval
using the Up or Down key, then press Enter. Set the
second character using the same Up or Down key,
etc.
• After defining the last character, press the Enter key
to validate the recording interval. The screen displays
the entered interval (e.g. “REC INT:20.0s”)
6. For the static “rover” only, enter the approximate length
of the baseline:
• Return to the SURVEY:STATIC root menu, press Enter,
press the Up key twice and then enter this length
(
ESTIMATED BASELINE LEN:xxxkm). This parameter is
very important as it will be used by the Z-Max.Net to
help you determine the end of data collection.
Starting Data Collection
1. Start raw data logging as follows:
• Return to the root menu and then press the Down key
until
SESSIONS is displayed
•Press Enter. START SESSION is now displayed.
• Press Enter again. Start Session? is now displayed.
• Press Enter again. DONE is displayed for a few sec-
onds. Data logging is now in progress as indicated on
the Data Log LED which should blink green
once at
the frequency of the data recording interval
.
End of Data Collection
1. Return to the SURVEY:STATIC root menu, press Enter,
press the Up key twice. The screen should now display
the
ESTIMATED BASE LINE LEN parameter.