User's Manual
Table Of Contents
- What is MobileMapper 100?
- First-Time Use
- Unpacking
- Charging the Battery for the First Time
- Inserting the Battery Into the Receiver
- Turning the Receiver On
- Adjusting Backlight Level
- Setting Backlight Idle Time
- Power Management
- Regional Settings
- Locking the Screen and the Keypad
- How to Hold the Receiver
- Switching to Suspend Mode
- Turning the Receiver Off
- System Description
- Special Features
- Using MobileMapper Field Software
- Post-Processing Option and MobileMapper Office
- GNSS Toolbox
- Installing Geoids
- Platform Specifications
English
6
enough satellites are tracked, you can start using your
receiver and run your application software.
Switching to
Suspend Mode
Switching the receiver to Suspend mode is the right thing to
do when you need to make a short pause in your work. In
Suspend mode, the receiver is idle, using the minimum of
energy required to save the use context.
To switch to Suspend mode, just press briefly on the Power
button [8].
To wake up the receiver, hold the same button pressed ntil the
screen wakes up. This will instantly restore the use context in
which the receiver was before entering the Suspend mode.
Turning the
Receiver Off
After you have finished your field work, turn off your receiver
by holding the Power button [8] pressed until the message
“Saving Parameters..” is displayed on the screen.
The power shutdown will be effective after about 25 seconds.
Tapping OK in the upper-right corner of the screen will not
affect the progress of the power shutdown sequence but
simply close the message window. There is indeed no way of
shortening or canceling the power shutdown sequence.
[8]