User's Manual
Table Of Contents
- What is MobileMapper 100?
- First-Time Use
- Unpacking
- Charging the Battery for the First Time
- Inserting the Battery Into the Receiver
- Turning the Receiver On
- Adjusting Backlight Level
- Setting Backlight Idle Time
- Power Management
- Regional Settings
- Locking the Screen and the Keypad
- How to Hold the Receiver
- Switching to Suspend Mode
- Turning the Receiver Off
- System Description
- Special Features
- Using MobileMapper Field Software
- Post-Processing Option and MobileMapper Office
- GNSS Toolbox
- Installing Geoids
- Platform Specifications
English
16
•Tap Next (bottom of the screen).
•Enter the Access point name. This information should have
been passed on to you by your ISP.
•Tap Next.
• Enter the following information, also passed on to you by
your ISP when purchasing the SIM card:
– User Name
– Password
– Domain (if required by your ISP)
•Tap Finish. This takes you back to the initial Connections
screen on which a new hyperlink is now displayed (Manage
existing connections).
You will use this hyperlink to re-access the connection
profile you have just created (see below).
Activating the Internet Connection
•Tap Start, Settings, Connections and Connections.
• Tap on the hyperlink: Manage existing connections.
• Tap and hold the name of the connection profile you have
just created (e.g. “My Connection”) and select Connect.
• Take a look at the Start bar and check that the Connect
icon looks like this after the GPRS connection has been
established:
A click on this icon will show you the active connection(s).
CDMA Connection
Using an External
Mobile Phone
Connecting the receiver to a CDMA network requires the use
of an external mobile phone compatible with this type of
network.
The receiver will communicate with the CDMA network via
the mobile phone, and a Bluetooth connection with be used
between the receiver and the mobile phone.
Bluetooth
CDMA
Internet