User's Manual
Table Of Contents
- What is MobileMapper 100?
- First-Time Use
- Unpacking
- Charging the Battery for the First Time
- Inserting the Battery Into the Receiver
- Turning the Receiver On
- Adjusting Backlight Level
- Setting Backlight Idle Time
- Power Management
- Regional Settings
- Locking the Screen and the Keypad
- How to Hold the Receiver
- Switching to Suspend Mode
- Turning the Receiver Off
- System Description
- Special Features
- Using MobileMapper Field Software
- Post-Processing Option and MobileMapper Office
- GNSS Toolbox
- Installing Geoids
- Platform Specifications
English
18
• When the Bluetooth connection is established, the
receiver screen lists the Bluetooth services available from
your mobile phone. Make sure the Dialup Networking option
is enabled.
•Tap Save to complete the connection procedure. This
takes you back to the Bluetooth Settings window on which
you can now see your phone as a properly connected unit.
•Tap OK to close this window.
•Tap Done (at the bottom of the screen) to close the window
and return to the Start screen.
Setting Up the Internet Connection
•Tap Start, Settings, Connections, Connections
• Tap on the Advanced tab
• Tap on the Select Networks button, then on the New button
• Enter a name identifying the network connection (e.g.
“CDMA”)
• Tap on the Modem tab, then on the New button
• Enter a name identifying the connection to this network
(e.g. “Ext. Mobile Phone”)
• In the field underneath, select “Bluetooth” as the modem
used.
•Tap Next
To be comp leted..